Zero your LH-4
1. Bore-Sighting Preparation: Begin by bore-sighting your rifle. This ensures that the initial shots are close to the point of aim. 2. Firing Initial Rounds: Fire a series of three to five rounds at the target. 3. Measure POA vs. POI: Determine the difference between the point of aim (POA) and the point of impact (POI). Use the reticle or a measuring device on the target. 4. Adjust Elevation and Windage: Using the adjustment turrets, make necessary changes to align the POA with the POI. 5. Confirmation Rounds: Fire an additional three to five rounds to verify the zero. Continue adjustments until the POA and POI coincide. Please note: Each click of the turret represents a specific angular measurement. Familiarize yourself with your scope's specifications for accurate adjustments. Zero-Reset Once your scope is zeroed, start by loosening the Tool-Less thumb cap which is located directly in the center of the elevation or windage turret (please be sure to hold turret itself while unscrewing the cap counterclockwise). After you have loosened the cap fully, lift it off. The turret can now be lifted up. Realign the '0' of the turret with the scale line on the scope of the body. After alignment, securely tighten the thumb cap back in place (by screwing it clockwise) to complete the Zero-Reset process
10
Powered by FlippingBook